Installation Instructions

FormNo.3361-678RevA

TallGrassKit

Groundsmaster5900/5910CuttingUnits

ModelNo.117–2795

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Deectorplate,right

Deectorplate,left

Retainernut4

Buttonheadscrew4

Washer4

Carriagescrew

Flangenut4

Installdeectorplatesintocenterdeck

Deectorplate

Carriagescrew

Flangenut8

Installdeectorplatesintowingdecks

MediaandAdditionalParts

Description

Qty.

Use

Installationinstructions1

Partscatalog1

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3361-678 Rev A Tall Grass Kit Groundsmaster 5900/5910 Cutting Units Model No. 117–2795 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description 1 1 4 4 4 4 4 4 8 8 Deflector plate, right Deflector plate, left Retainer nut Button head screw Washer Carriage screw Flange nut Deflector plate Carriage screw Flange nut 1 2 Use Qty.
PAGE 2
. Position the deflector plates so the mounting holes align with the mounting tabs/retainer nuts and the holes in the mower housing (Figure 1). 1 3. Loosely install the rear of each deflector to the mounting tabs/retainer nuts with 2 button head screws and washers (Figure 1). Install the Deflector Plates into Center Deck 4. Loosely install the front of each deflector to the inside of the mower housing with 2 carriage screws and flange nuts (Figure 1).
PAGE 3
2 Install the Deflector Plates into Wing Decks Parts needed for this procedure: 4 Deflector plate 8 Carriage screw 8 Flange nut Procedure 1. Position the deflector plates so the mounting holes align with the mounting holes in the deck baffles (Figure 2). 2. Align the deflector plates with the outside of the deck baffles. Secure each deflector plate to the baffles with 2 carriage screws and flange nuts (Figure 2). Figure 2 1.
PAGE 4