Installation Instructions

ManualsBrandsToro ManualsAttachmentsWorklight Kit, Workman HD/HDX/HDX-D Utility Vehicle

FormNo.3432-328RevA

WorklightKit

Workman

HD/HDX/HDX-DUtilityVehicle

ModelNo.117-4827

InstallationInstructions

Safety

SafetyandInstructional

Decals

Safetydecalsandinstructionsare

easilyvisibletotheoperatorandare

locatednearanyareaofpotential

danger.Replaceanydecalthatis

damagedormissing.

decal107-8008

107-8008

1.Worklight—rear

2.Worklights—front

decal107-8011

107-8011

1.Work-lightfuse—15A

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3432-328*A

Summary of content (4 pages)

PAGE 1
Form No. 3432-328 Rev A Worklight Kit Workman® HD/HDX/HDX-D Utility Vehicle Model No. 117-4827 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal107-8008 107-8008 1. Work light—rear 2. Work lights—front decal107-8011 107-8011 1.
PAGE 2
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 Description Use Qty. No parts required – Wire harness Switch Work light decal (107-8008) Fuse (15 A) Fuse decal (107-8011) Work light assembly Bolt (5/16 x 3/4 inch) Locknut (5/16 inch) Light channel Channel-mounting bracket Bolt (1/4 x 2-3/4 inches) Washer Flange nut (1/4 inch) Cable tie 1 1 1 1 1 1 4 4 2 4 4 4 4 8 1 Prepare a machine. Install the wiring. Install the work lights.
PAGE 3
Part No. 92-2641) next to the current blocks, and connect the spade connector to a slot in the new fuse block. 3. Insert the fuse (15 A) into the fuse block location to which you connected the spade connector (Figure 1). 4. Connect the ring terminal on the black wire to the grounding block (Figure 1). 5. Apply the work light fuse decal (107-8011) in the corresponding open spot on the existing fuse decal (Figure 1). g010721 Figure 2 1. Work light decal g010720 Figure 1 1. Fuse block 3.
PAGE 4
Important: Ensure that you route the wire 3 harness through the left channel bracket to the left, rear side of the roll bar. Note: If the machine is equipped with a cab, mount the light channels to the top of the roll bar and install a channel cap (available through your Toro Distributor) onto the curved end of each channel. Installing the Work Lights Parts needed for this procedure: 4.