Installation Instructions

ManualsBrandsToro ManualsAttachmentsReplacement Stabilizer Spring Kit, Greensmaster 3300/3400 Series Traction Unit

FormNo.3370-309RevB

ReplacementStabilizerSpringKit

Greensmaster

3300/3400SeriesTractionUnit

ModelNo.117-6842

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Right-handspringretainer3

Left-handspringretainer

Right-handstabilizerspring3

Left-handstabilizerspring

Spacer

Mountingbolt6

Flangenut6

Installthekit.

1.Movethemachinetoalevelsurface,andlowerall

thecuttingunitstotheground.

2.Stopthemachine,waitforallmovingpartstostop,

settheparkingbrake,andremovethekeyfromthe

ignition.

3.Removetheexistingspringsandspringretainers

fromasuspensionarm.

Note:Savetheadjustmentboltsthatholdthespring

retainersontothesuspensionarm.

4.Installthenewleft-andright-handspringand

retainerassembliesontothesuspensionarmas

shownin

Figure1.

G017712

Figure1

Right-handspring-and-retainerassemblycomponents

shown

1.Suspension

arm

4.Flangenut

7.Stabilizing

spring

2.Springretainer

5.Mountingbolt

3.Adjustmentbolt

(existing)

6.Spacer

Note:Handtightentheadjustmentboltandthe

mountingboltandangenut.

Note:Fortherstspring-and-retainerassemblythat

youinstall,positiontheadjustmentboltinthecenter

oftheslotinthespringretainer(Figure2).Forthe

spring-and-retainerassemblyontheothersideofthe

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

Summary of content (2 pages)

PAGE 1
Form No. 3370-309 Rev B Replacement Stabilizer Spring Kit Greensmaster® 3300/3400 Series Traction Unit Model No. 117-6842 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Right-hand spring retainer Left-hand spring retainer Right-hand stabilizer spring Left-hand stabilizer spring Spacer Mounting bolt Flange nut 3 3 3 3 6 6 6 Install the kit. 1 1.
PAGE 2
suspension arm, you may position the adjustment bolt anywhere in the slot in the spring retainer. 1 2 G017713 Figure 2 1. Adjustment bolt located in the center of the slot 2. Spring retainer 5. Repeat steps 3 and 4 for the other 2 suspension arms. 6. Raise the cutting units. 7. Ensure that the cutting units are perpendicular to the forward direction of travel.