Installation Instructions

FormNo.3362-475RevA

RearGuardKit

forProCoreSR54,SR70andSR72Aerators

ModelNo.117–7105

ModelNo.117–7106

ModelNo.117–7107

InstallationInstructions

Installation

1.Insertthesquareplasticplugsintotheendsofthe

rearguardtubes(Figure1).

2.Aligntheholesintherearguardmountingtubes

withtheholesintheaeratorsideplates(Figure1).

3.Securetheguardmountingtubestothesideplates

with(4)screws,spacersandnuts.Thespacersareto

bepositionedbetweenthetubesandthesideplates

(Figure1).

4.CleanthesurfaceofthedecalonthePTOshaft

outershieldandtheoutertube.Afxthenew

warningdecaloverthedecal.

5.CleanasmallareaonthePTOshaftoutershield.

AfxtheCEmarkdecalontotheoutershield.

6.InsertthePTOshaftOperator’sManualintothe

manualtubelocatedontheaeratorframecover.

G010984

Figure1

GuardforModelSR54Shown

1.Rearguard

4.Screw

2.Squareplasticplugs5.Spacer

3.Sideplates

6.Nut

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3362-475 Rev A Rear Guard Kit for ProCore SR54, SR70 and SR72 Aerators Model No. 117–7105 Model No. 117–7106 Model No. 117–7107 Installation Instructions Installation 4. Clean the surface of the decal on the PTO shaft outer shield and the outer tube. Affix the new warning decal over the decal. 1. Insert the square plastic plugs into the ends of the rear guard tubes (Figure 1). 5. Clean a small area on the PTO shaft outer shield. Affix the CE mark decal onto the outer shield. 2.