Installation Instructions

FormNo.3364-568RevA

RearGuardKit

ProCore

SRSeriesAerator

ModelNo.117-7105

ModelNo.117-7106

ModelNo.117-7107

ModelNo.119-1010

ModelNo.119-1011

InstallationInstructions

Installation

AssembletheRearGuard

RearGuardforSR75Aeratoronly

AssembletherearguardasshowninFigure1.

Figure1

RearguardforSR75aeratorshown

1.Rearguardend

4.Hexheadbolt,3/8x1-3/4inch(4)

2.Locknut(4)5.Rearguardmountingtube(2)

3.Squareplasticplug(4)

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

PAGE 1
Form No. 3364-568 Rev A Rear Guard Kit ProCore® SR Series Aerator Model No. 117-7105 Model No. 117-7106 Model No. 117-7107 Model No. 119-1010 Model No. 119-1011 Installation Instructions Installation Assemble the Rear Guard Rear Guard for SR75 Aerator only Assemble the rear guard as shown in Figure 1. Figure 1 Rear guard for SR75 aerator shown 1. Rear guard end 2. Locknut (4) 3. Square plastic plug (4) © 2010—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 4.
PAGE 2
Install the Rear Guard 4. Clean the surface of the decal on the PTO shaft outer shield and the outer tube, and affix the new warning decal over the existing decal. 1. Insert the square plastic plugs into the ends of the rear guard tubes (Figure 2). 5. Clean a small area on the PTO shaft outer shield, and affix the CE mark decal onto the outer shield. 2. Align the holes in the rear guard mounting tubes with the holes in the aerator side plates (Figure 2). 6.
PAGE 3
Installing the Lock Plate 1. Drill and tap 2 holes (3/8 inch–16 UNC) on each of the 2 sides of the cover as shown in the inset of Figure 3. 2. Install the each lock plate with 2 hex head bolts and 2 retaining rings (Figure 3). Figure 3 Rear guard for SR48 aerator shown 1. 2. 3. 4. 5. 6. Drill here 1/2 inch (13 mm) 1 inch (25 mm) 2-1/2 inches (64 mm) Rear guard assembly Locknut (4) 7. 8. 9. 10. 11. 12.
PAGE 4