Installation Instructions

ManualsBrandsToro ManualsAttachmentsFender Kit, Groundsmaster 7200 Series Traction Unit

Table Of Contents

FormNo.3395-948RevA

FenderKit

Groundsmaster7200SeriesTractionUnit

ModelNo.117–9170

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Fendermount1

Rightfender

Thread-formingscrew(5/16x5/8inch)

Bolt(1/4x5/8inch)

Nut(1/4inch)

Installtherightfender.

Leftfender

Nut(3/8inch)

Bolt(3/8x3/4inch)

Installtheleftfender.

PreparingtheMachine

1.Positionasuitableoorjackundertherearbumper

tubeandraisethereartiresofftheground(Figure1).

Note:Positionthejackstandsundertherearbumper.

Figure1

1.Rearbumpertube2.Floorjack

2.Removetherearwheels.

3.Removealldebrisfromthewheel-wellarea,including

anydebriscaughtinthebrakeassembly.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3395-948*A

Summary of content (4 pages)

PAGE 1
Form No. 3395-948 Rev A Fender Kit Groundsmaster 7200 Series Traction Unit Model No. 117–9170 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty.
PAGE 2
Installing the Right Fender 5. Use the frame mount as a template to locate and mark the other 2 fender mounting holes in the frame channel (Figure 4). 1. Remove the bolt securing the hose clamp to the frame channel on the right side of the machine (Figure 2). Figure 2 1. Hose clamp Figure 4 2. Bolt 1. Mark here. 6. Remove the bolt and nut securing the clamp and fender mount to the frame (Figure 5). 2. Insert the bottom of the hose clamp through the slot in the top of the fender mount (Figure 3).
PAGE 3
Installing the Left Fender 9. Using the newly drilled holes, secure the fender mount to the frame channel with 2 thread-forming screws (5/16 x 5/8 inch) as shown in Figure 6. 1. Disconnect the cable from the negative terminal of the battery. 2. Disconnect the cable from the positive terminal of the battery. 3. Remove the carriage bolt, washer, battery hold-down, and nut securing the battery (Figure 8). Note: Retain the hold-down and the fasteners. Figure 6 1. Thread-forming screw (5/16 x 5/8 inch) 10.
PAGE 4
13. Remove the jack stands and lower the machine. 6. Loosely mount the bracket on the top of the left fender to the fuel-tank bracket with 2 bolts (3/8 x 3/4 inch) and 2 nuts (3/8 inch) as shown in Figure 9. Note: Verify that the tires do not rub on the fenders when you drive the machine. Figure 9 1. Fuel-tank bracket 2. Left fender 7. Position the battery onto the battery platform. 8.