Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 119-3320

FormNo.3364-634RevA

48inRecycler

Kit

TITANZero-Turn-RadiusRidingMower

ModelNo.119-3320

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Rightbafe

Leftbafe

Bafeguard

Locknut(5/16inch)

Carriagebolt(5/16x3/4inch)

Kickerbafes

Flangescrew(5/16x3/4inch)

Decal1

Mulchingblade3

InstalltheRecycler®Kit.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (4 pages)

PAGE 1
Form No. 3364-634 Rev A 48in Recycler® Kit TITAN Zero-Turn-Radius Riding Mower Model No. 119-3320 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Right baffle Left baffle Baffle guard Lock nut (5/16 inch) Carriage bolt (5/16 x 3/4 inch) Kicker baffles Flange screw (5/16 x 3/4 inch) Decal Mulching blade © 2010—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Use Qty.
PAGE 2
Installing the Recycler® Kit 1 1. Stop the engine and remove the ignition key. 2. Remove the mower as described in your Operator’s Manual. 3. Turn the mower upside down. 4. Remove the existing mower blades installed on your deck. Refer to the Removing the Blades section in the Operator’s Manual for more information. 5. Locate the cut off baffle at the side discharge opening on the mower deck (Figure 1). G012805 2 1 3 Figure 2 2 3. Welded posts 1. Lock nut (5/16 inch) 2. Right baffle 3 9.
PAGE 3
1 G012841 1 2 3 Figure 6 Figure 4 1. Lock nut (5/16 inch) 2. Carriage bolt (5/16 x 3/4 inch) 1. Decal 3. Left baffle A. Thoroughly clean the area where you will install the decal. 13. Locate a carriage bolt (5/16 x 3/4 inch) and a lock nut (5/16 inch) from loose parts. Install the carriage bolt and lock nut through side wall of the mower deck and left baffle to secure the baffle to the deck. B. Dampen the area with water or mildly soapy water. C.
PAGE 4
Operation Cleaning After Operating Operating Tips To ensure optimum performance, clean the underside of the mower housing. If residue is allowed to build up in mower housing, cutting performance will decrease. Selecting the Proper Height-of-Cut Setting to Suit the Conditions Remove approximately one inch or no more that 1/3 of the grass blade when cutting.