Installation Instructions

FormNo.3365-683RevA

ReplacementThrottleCableKit

SandPro

3040/5040TractionUnit

ModelNo.119-7188

InstallationInstructions

InstallingthenewThrottle

Cable

Note:Ensurethethrottlecabledoesnotgetkinkedor

bent.Avoidkinksorbendsbyensuringthecabledoes

notmakesharpcorners.

1.Removethethreeboltsholdingthecontrolpanelto

themachineandremovethecontrolpanel(

Figure1).

2.Removethetwoboltsholdingtheexistingthrottle

cablelevertothecontrolpanel.Savethesebolts

(

Figure1).

G014056

Figure1

1.Controlpanelbolts

2.Throttlecablebolts

3.Loosenthe2screwssecuringthecentershroudto

themachineandremovetheshroud(Figure2).

Figure2

1.Centershroud

4.Pivottheseatupward.

5.Removethrottlecablefromtheengineswivel,engine

clampandR-clampunderthecentershroud.

6.Routethecabledownthecenterofthecontrol

panel,throughtheR-clamp,overthehydraulichoses,

backtotheengineandthroughtheengineclamp

(

Figure3).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3365-683 Rev A Replacement Throttle Cable Kit Sand Pro® 3040/5040 Traction Unit Model No. 119-7188 Installation Instructions Installing the new Throttle Cable Note: Ensure the throttle cable does not get kinked or bent. Avoid kinks or bends by ensuring the cable does not make sharp corners. 1. Remove the three bolts holding the control panel to the machine and remove the control panel (Figure 1). 2. Remove the two bolts holding the existing throttle cable lever to the control panel.
PAGE 2
4 1 2 3 G014154 Figure 4 1. Throttle casing clamp screw 2. Throttle cable 3. Swivel 4. Stop 5. Choke casing clamp screw 6. Choke cable 3. Move the remote throttle control lever forward to the Fast position. 5 G014057 4. Pull firmly on the throttle cable until the back of the swivel contacts the stop (Figure 4). Figure 3 1. Engine 2. R-clamp 4. Hydraulic hoses and hardlines 5. Front view of throttle cable and hydraulic hardlines 5.