Addendum

FormNo.3373-966RevA

SpeedControlRemovalKit

2010andBeforeGrandStand

Mower

ModelNo.119-7380

Addendum

InstallingtheCableLock

Note:Discardtheoriginalspringclipthatwasinstalledon

thecrossbracket(step40).Usethecablelockinitsplace.

1.Applythehydraulictrackingdecal(119–1854)tothe

crossbracketlistedinstep51beforeinstallingthecable

lockinstep40.

2.Installthecablelockontothecableadjustingnutsto

securetheadjustment(

Figure1).

UsingtheCableLock

Removethecablelocktoadjustthetrackingoralignthe

motioncontrolleversfronttoback.

1.Liftandremovethecablelocksecuringthecable

adjustingnuts(Figure1).

2.Adjustthetrackingoralignthemotioncontrollevers

fronttoback.RefertotheOperator’sManualforthe

correctprocedures.

3.Installthecablelockontothecableadjustingnutsto

securetheadjustment(Figure1).

g018782

Figure1

1.Leftcableadjustment

3.Rightcableadjustment

2.Cablelock

4.Alignthecableadjustment

nutstoinstallthecable

lock

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3373-966*A

PAGE 1
Form No. 3373-966 Rev A Speed Control Removal Kit 2010 and Before GrandStand® Mower Model No. 119-7380 Addendum 3 Installing the Cable Lock Note: Discard the original spring clip that was installed on the cross bracket (step 40). Use the cable lock in its place. 1. Apply the hydraulic tracking decal (119–1854) to the cross bracket listed in step 51 before installing the cable lock in step 40. 2. Install the cable lock onto the cable adjusting nuts to secure the adjustment (Figure 1).
PAGE 2