Installation Instructions

ManualsBrandsToro ManualsRiding ProductsDeck Stop Replacement Kit, Groundsmaster 5900/5910 Traction Unit

FormNo.3364-775RevA

DeckStopReplacementKit

Groundsmaster

5900/5910TractionUnit

ModelNo.119–7700

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Removethesidecuttingunits

Stopassembly

Bolt,3/8x1–1/2inch(Grade8)

Washer4

Installthestopassemblies

Stoppad

Stopshim

Rivet4

Installthestoppads

Nopartsrequired

–

Installthesidecuttingunits

RemovingtheSideCutting

Units

1.Positionthemachineonalevelsurface,lowercutting

unit,stoptheengine,engagetheparkingbrakeand

removethekeyfromtheignition.

2.Removecuttingunitoutercovertoaccesshydraulic

deckmotor.

3.Remove(3)hoseguidesfromcuttingunit(

Figure1).

The(2)guides,aroundthehoses,canstayonthe

hydraulichoses.

G010083

Figure1

1.Hoseguide

4.Removetheboltssecuringthehydraulicmotorto

thecuttingunit(Figure2).Liftthemotoroffofthe

cuttingunitandpositionitawayfromthecutting

unit.

Figure2

1.Hydraulicmotor2.Mountingbolts

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (4 pages)

PAGE 1
Form No. 3364-775 Rev A Deck Stop Replacement Kit Groundsmaster® 5900/5910 Traction Unit Model No. 119–7700 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Stop assembly Bolt, 3/8 x 1–1/2 inch (Grade 8) Washer Stop pad Stop shim Rivet 1 4 4 1 2 4 No parts required – Removing the Side Cutting Units 1.
PAGE 2
resting on the top of the deck connection bracket as shown in Figure 5, inset. 5. Remove (8) flange head screws and lock nuts that secure deck connection to cutting unit (Figure 3). Figure 3 1. Deck connection 2. Mounting bolts (8) Figure 5 1. Stop assembly 6. Raise lift arm enough to separate deck connection from cutting unit. 7. Slide the cutting unit away from the traction unit. Installing the Stop Pads 1. Using the dimensions shown in Figure 6, locate, mark and drill (4) .259 ± .
PAGE 3
key to run and hold lower switch while pulling down on lift arm. 5. Lower the lift arm while aligning the deck connection to the cutting unit. 6. Turn the key switch off and remove the key from the ignition. 7. Install the deck connection to the cutting unit with (8) flange head screws and lock nuts previously removed (Figure 3). Torque the bolts to 67-83 ft-lb (91-112 N-m). 8. Install the hydraulic motor to the cutting unit with the bolts previously removed (Figure 2).
PAGE 4