Installation Instructions

ManualsBrandsToro ManualsAttachmentsCanopy for Four-Post Roll-Over Protection System Kit, Workman HD/HDX/HDX-D Utility Vehicle

FormNo.3365-329RevA

CanopyforFour-PostRoll-OverProtectionSystem

Kit

WorkmanHD/HDX/HDX-DUtilityVehicle

ModelNo.119–9457

InstallationInstructions

Installation

Important:Beforethecanopycanbeinstalled,

theFourPostRollOverProtectionSystem,Model

07378mustbeinstalledontheWorkmanUtility

Vehicle.

Note:Determinetheleftandrightsidesofthemachine

fromthenormaloperatingposition.

1.Stoptheengine,settheparkingbrakeandremove

thekeyfromtheignition.

2.Removethetwoangeheadboltsandange

nutssecuringtherightROPSposttotherollbar

(

Figure1).

G010774

Figure1

1.RightROPSpost

3.Usingtheboltsandnutsremoved,looselymount

therightrearcanopybrackettotherightROPSpost

(Figure2).

Note:Whentightened,atleasttwoboltthreads

mustextendoutofthenuts.Iftheexistingboltsare

toshort,usethe1/2x3–1/2inchboltsincluded

withthekit.

Figure2

1.Rightrearcanopybracket

4.Leftfrontcanopybracket

2.Leftrearcanopybracket

5.Frontcentercanopy

bracket

3.Rightfrontcanopybracket

4.Repeattheproceduretoinstalltheleftrearcanopy

bracket.

5.Removethetwoangeheadbolts,washersand

angenutssecuringtherightendofthecrossbarto

therightROPSpost(

Figure3).

G010775

Figure3

1.Crossbar

6.Looselymounttherightfrontcanopybracketto

therightROPSpostandcrossbarwithnew3/8x

3–3/4inchboltsandwashersandtheexistingnuts

(Figure2).

7.Repeattheproceduretoinstalltheleftfrontcanopy

bracket.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (2 pages)

PAGE 1
Form No. 3365-329 Rev A Canopy for Four-Post Roll-Over Protection System Kit Workman HD/HDX/HDX-D Utility Vehicle Model No. 119–9457 Installation Instructions Installation Important: Before the canopy can be installed, the Four Post Roll Over Protection System, Model 07378 must be installed on the Workman Utility Vehicle. Note: Determine the left and right sides of the machine from the normal operating position. 1. Stop the engine, set the parking brake and remove the key from the ignition. 2.
PAGE 2
8. Loosely mount the front canopy bracket to the center of the crossbar with the U-bolt and 5/16 inch nuts (Figure 2). 9. Position the canopy onto the ROPS aligning it’s mounting holes with the holes in the brackets (Figure 4). Figure 4 1. Canopy 2. Bolt 3. Washer 4. Rubber bushings 5. Nut 10. Loosely mount the canopy to the brackets with (5) 1/4 x 1–1/4 inch bolts, 7/8 inch washers and 1/4 nuts.