Installation Instructions

ManualsBrandsToro ManualsAttachmentsLanyard Kit, 2011 and After Workman MD Series Utility Vehicle

FormNo.3366-616RevB

LanyardKit

2011andAfterWorkman

MDSeriesUtilityVehicle

ModelNo.119-9590

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Lanyardrod1

Tailgatelanyards2

Hexheadbolts2

Flatwashers2

Strikermounts

Flatheadscrews2

Installthekit.

InstallingtheKit

1.Removethe2strikersandstrikermountsfromthe

Workmanbed(Figure1).

Figure1

1.Strikermount(2)3.Screws

2.Striker(2)

2.Separateeachstrikerfromthestrikermountby

removingthetwoscrews(Figure1).

Note:Savethestrikersforthenextstep.

3.Installoneendofthelanyardonthebottompostof

thestriker,thenattachthestrikerstothenewstriker

mountswiththescrewsthatyouremovedinthe

previousstep(Figure2).

Figure2

1.Flatheadscrew(2)inthelargerholeonthestrikemount

Note:Thelargerholeonthestrikermountshould

beorientedtowardthebottom(Figure2).

4.Installeachofthe2strikersandnewstrikermounts

totheWorkmanbedusingoneoftheboltsthatyou

removedinstep1andaat-headscrew(Figure2).

5.Knockouttheholeplugineachendofthetailgate

(Figure3).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

Summary of content (2 pages)

PAGE 1
Form No. 3366-616 Rev B Lanyard Kit 2011 and After Workman® MD Series Utility Vehicle Model No. 119-9590 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Lanyard rod Tailgate lanyards Hex head bolts Flat washers Striker mounts Flat head screws 1 2 2 2 2 2 Install the kit. Installing the Kit 1. Remove the 2 strikers and striker mounts from the Workman bed (Figure 1). Figure 2 1.
PAGE 2
Figure 3 1. Hole plug (2) 6. Insert the lanyard rod through the tailgate so that both ends of the rod are exposed (Figure 4). Figure 4 1. Hex head bolt (2) 2. Flat washer (2) 3. Lanyard (2) 4. Lanyard rod 7. Lift and hold the tailgate in place, and secure the lanyards to the lanyard rod using a flat washer and a hex head bolt on each rod end (Figure 4).