Installation Instructions

FormNo.3366-666RevB

Tie-DownKit

2011andAfterWorkman

MDSeriesUtilityVehicle

ModelNo.119-9605

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Tiedown4

Hex-socketbolt(M6x1inch)—2013models

andolder

Locknut(M6)—2013modelsandolder

Installthetie-downkit(2013modelsandolder).

Tiedown4

Hex-headscrew(1/4x3/4inch)—2014

modelsandnewer

Installthetie-downkit(2014modelsandnewer).

InstallingtheTie-DownKit(for2013ModelsandOlder)

1.Locatethedrillmarksinall4cornersofthebed(Figure1).

G014750

Figure1

1.Drillmarks

2.Drilla7/32inchdiameterholehere.

2.Drilla7/32inchdiameterholeateachdrillmark(Figure1).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3366-666*B

PAGE 1
Form No. 3366-666 Rev B Tie-Down Kit 2011 and After Workman® MD Series Utility Vehicle Model No. 119-9605 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Tie down Hex-socket bolt (M6 x 1 inch)—2013 models and older Locknut (M6)—2013 models and older Tie down Hex-head screw (1/4 x 3/4 inch)—2014 models and newer 4 8 Install the tie-down kit (2013 models and older). 8 4 Install the tie-down kit (2014 models and newer).
PAGE 2
3. Install a tie down at each pair of drilled holes (Figure 2). 1 2 3 4 G014751 Figure 2 1. Hex-socket bolt (M6 x 1 inch) 3. Drilled holes 2. Tie down 4. Locknut (M6) 4. Secure each tie down to the bed with 2 hex-socket bolts (M6 x 1 inch) and 2 locknuts (M6) as shown in Figure 2. Note: Tighten the locknuts until snug, but do not overtighten. Installing the Tie-Down Kit (for 2014 Models and Newer) 1. Install a tie down at each pair of holes (Figure 3).