Installation Instructions

FormNo.3369-793RevA

CableSupportKit

Greensmaster

3300,3320,3400,and3420TriFlex™TractionUnits

ModelNo.120-2018

ModelNo.120-2019

ModelNo.120-2020

InstallationInstructions

RemovingtheComponents

fromtheOldCableSupport

Plate

Note:Saveallthecomponentsthatyouremovefrom

theexistingcablesupportplatesothatyoucaninstall

themonthenewcablesupportplate.

1.Removethedamperandhardwarefromtheexisting

cablesupportplate.

2.Removethetractioncablefromtheexistingcable

supportplate.

3.Removetheneutralcenteringdeviceandthespring

fromtheexistingcablesupportplate.

ReplacingtheCableSupport

Plate

1.Removethe2boltsthatsecuretheexistingcable

supportplatetothehydrostat.

Note:Donotdiscardthebolts;savethemfor

installingthenewcablesupportplate.

2.Removeanddiscardtheexistingcablesupportplate.

3.Installthenewcablesupportplatetothehydrostat

withthe2boltsthatyoupreviouslyremoved.

Note:ApplyNeverSeez(Toropart505-181)onto

thepivotbushing(

Figure1orFigure2).

G017412

Figure1

ForDieselModelsonly

1.Hex-headscrew4.Damper

2.Nylonwasher5.Flangenut

3.Pivotbushing

6.Cablesupportplate

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

PAGE 1
Form No. 3369-793 Rev A Cable Support Kit Greensmaster® 3300, 3320, 3400, and 3420 TriFlex™ Traction Units Model No. 120-2018 Model No. 120-2019 Model No. 120-2020 Installation Instructions Removing the Components from the Old Cable Support Plate Note: Save all the components that you remove from the existing cable support plate so that you can install them on the new cable support plate. 1 2 4 3 1. Remove the damper and hardware from the existing cable support plate. 2.
PAGE 2
Adjusting the Transmission for Neutral 1 If the machine creeps when the traction control pedal is in the neutral position, adjust the neutral return mechanism. 4 2 1. Block up under the frame so that one of the front wheels is off the floor. 3 Note: If machine is equipped with a 3-wheel drive kit, also raise and block the rear wheel. 2. Start the engine, move the throttle to Slow, and ensure that the front wheel is both off the floor and not rotating. 2 5 3.