Installation Instructions

ManualsBrandsToro ManualsRiding ProductsFilter Relocation Kit, Greensmaster 3150

FormNo.3367-208RevA

FilterRelocationKit

Greensmaster

3150

ModelNo.120-3171

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Fuelhose1

Smallplasticcabletie

Largeplasticcabletie1

800cccarboncanister1

Inlineventlter

Hoseclamp2

Bracket1

Clamp

Hexheadbolt(1/4x5/8inch)

Hexangenut

Installthekit.

1.Removethefastenersthatholdtheright-hand

consoleinplace,andremovetheconsole(Figure1).

Figure1

1.Fasteners

2.Removeanddiscardthecarboncanisterwiththe

in-lineventlterandtheshortconnectinghose.

3.Installanewcarboncanisterfromlooseparts.

4.Connectthehosestothettingsontopofthe

canister,andsecurethemusingtheexistinghose

clamps.

5.Secureoneendofthenewfuelhose(fromtheloose

partsbag)tothebottomofthecarboncanisterwith

anewhoseclamp(Figure2).

Figure2

1.Carboncanister

3.Fuelhose

2.Hoseclamp4.Largeplastictie

6.Securethefuelhosetothecanisterwiththelarge

plastictieasshowninFigure2.

Note:Ensurethatthehosedoesnotkinkor

collapsewhenyouinstallthelargeplastictie.

7.Routethefuelhosebyfollowingthewireharness,

andsecurethehosetothewireharnesswithsmall

cableties(Figure3).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

Summary of content (2 pages)

PAGE 1
Form No. 3367-208 Rev A Filter Relocation Kit Greensmaster® 3150 Model No. 120-3171 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Fuel hose Small plastic cable tie Large plastic cable tie 800 cc carbon canister Inline vent filter Hose clamp Bracket Clamp Hex head bolt (1/4 x 5/8 inch) Hex flange nut 1 3 1 1 1 2 1 1 1 1 Install the kit. 1.
PAGE 2
12. Slip on a hose clamp on the open end of the fuel hose and insert the new inline vent filter. 13. Secure the vent filter to the hose with a hose clamp (Figure 5). Note: Ensure that the open end of the vent filter is horizontal or lower. 14. Tighten the hex bolt and the nut to secure the hose. 15. Install the console. Figure 3 1. Wire harness 2. Small cable tie (3) 3. Hose 8. Remove the bolt that secures the side shield to the frame, and install a bracket from loose parts as shown in Figure 4.