Installation Instructions

ManualsBrandsToro ManualsAttachmentsBed Pivot Reinforcement Kit, 2011 Workman MD/MDX/MDE Series Utility Vehicle

FormNo.3370-530RevA

BedPivotReinforcementKit

2011Workman

MD/MDX/MDESeriesUtilityVehicle

ModelNo.120-4973

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Reinforcementbracket

Reinforcementplates

Carriagebolt

Flangenut2

Assemblethereinforcementbracket.

RemovingtheCargoBed

NoPartsRequired

Procedure

1.Raisethebedwithanelectriclift.

2.Removethecotterpinandclevisfromthetopofthe

liftactuator.Rotatetheactuatorforwardandlower

bedintothedownposition(

Figure1).

Figure1

1.Actuator

3.Clevis

2.Upperliftbracket4.Cotterpin

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (4 pages)

PAGE 1
Form No. 3370-530 Rev A Bed Pivot Reinforcement Kit 2011 Workman® MD/MDX/MDE Series Utility Vehicle Model No. 120-4973 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 3 Description 2 2 2 2 Reinforcement bracket Reinforcement plates Carriage bolt Flange nut Use Qty. Assemble the reinforcement bracket. 1 Removing the Cargo Bed No Parts Required Procedure 1. Raise the bed with an electric lift. 2.
PAGE 2
3. Remove the four bolts holding the bed pivot to the rear frame (Figure 2). 2 Removing the Pivot Blocks No Parts Required Procedure 1. Remove the nuts holding the pivot blocks to the bed (Figure 3). G016794 Figure 2 1. Bed pivot 2. Bolts 4. With help from another person slide the bed rearward off the frame, then rotate the front up, placing the tailgate on the ground with suitable protection to prevent scratches. Figure 3 1. Pivot block bolts 2. Plate 3. Pivot 4. Nuts 2.
PAGE 3
Assembling the Reinforcement Bracket Parts needed for this procedure: 2 Reinforcement bracket 2 Reinforcement plates 2 Carriage bolt 2 Flange nut Figure 5 Procedure 1. Carriage bolt 4. Reinforcement bracket 2. Pivot block bolt 3. Reinforcement plate 5. Pivot 1. Loosely assemble the reinforcement plates to the bed using the long pivot block bolts. 4. Insert a reinforcement bracket on each side, from the bottom (Figure 5). 2.
PAGE 4
Reassembling the Bed No Parts Required Procedure 1. Reassemble the pivot blocks and pivot assembly to the bed (Figure 6). Figure 6 1. Carriage bolt 4. Reinforcement bracket 2. Pivot block bolt 3. Reinforcement plate 5. Pivot 2. Tighten the four serrated flange nuts to 17 ft-lbs. 3. With the help of another person, position the bed into the rear frame. 4. Align the pivot bracket to the rear frame and install the four flange bolts. 5.