Installation Instructions

ManualsBrandsToro ManualsAttachmentsFront Scraper Kit for Full Roller, 18in DPA Greensmaster Cutting Reel

FormNo.3432-979RevA

FrontScraperKit

18inand21inDPAGreensmaster

CuttingReel

ModelNo.120-9615

ModelNo.120-9616

ModelNo.120-9617

ModelNo.139-7411

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Scraper

Bolt2

Nut2

Clamp

Installthescraper.

PreparingtheMachine

NoPartsRequired

Procedure

RefertoyourcuttingunitOperator’sManualfor

instructionstopreparethemachineandcuttingunit

forinstallation.

InstallingtheScraper

Partsneededforthisprocedure:

Scraper

2Bolt

2Nut

Clamp

RemovingtheRoller

1.Removetheplowbolt,washer,andnutsecuring

oneoftheheight-of-cutarmstothecuttingunit,

sideplate(Figure1).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3432-979*A

Summary of content (2 pages)

PAGE 1
Form No. 3432-979 Rev A Front Scraper Kit 18in and 21in DPA Greensmaster® Cutting Reel Model No. 120-9615 Model No. 120-9616 Model No. 120-9617 Model No. 139-7411 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Prepare the machine. 2 Scraper Bolt Nut Clamp 1 2 2 2 Install the scraper.
PAGE 2
6. Center the scraper on the roller. 7. Move the scraper in or out until the desired roller clearance is attained. The scraper must not contact the roller. Make sure the scraper is parallel to the roller. 8. Tighten the bolts and nuts securing the clamps to the roller shaft. Torque them to 11 N-m (96 in-lb). 9. Center the roller and scraper between the height-of-cut arms. 10. Rotate the scraper down until the desired turf contact is attained. 11. Tighten the roller mounting screws.