Operator's Manual

Figure 45
1. Jam nut
2. Tie rod
4. R otate both tie rods to mo v e the front of the
tire inw ard or outw ard.
5. Tighten the tie rod jam n uts when the
adjustment is cor rect.
6. Ensure that there is full tra v el of the steering
wheel in both directions .
Maintaining the Primary
Drive Clutch
After ev er y 400 operating hours or yearly , clean
and lubricate the clutc h as follo ws:
1. Raise and latc h the carg o bo x.
2. Stop the engine , remo v e the k ey , and set the
parking brak e .
3. R emo v e the 3 bolts securing the co v er to the
clutc h and remo v e the co v er ( Figure 46 ).
Figure 46
1. Cover
2. Bolts
4. T horoughly clean the inside of the co v er
and the inner w orkings of the clutc h using
compressed air .
T he dust in the clutch will become
airbor ne and could dama ge y our ey es or
y ou could inhale it causing br eathing
dif ficulties.
W ear safety go g g les and a dust mask
or other ey e and r espirator y pr otection
when perf or ming this pr ocedur e.
5. Lubricate the mo ving par ts in the areas circled
in Figure 47 using T oro Dr y Lubricant Spra y ,
a v ailable through y our A uthorized T oro Dealer
or Distributor .
Figure 47
6. Install the clutc h co v er and secure it with the 3
bolts remo v ed previously .
Changing the Transaxle
Fluid
Chang e the transaxle fluid ev er y 800 operating
hours or yearly , whic hev er occurs first.
1. P osition the v ehicle on a lev el surface , set
the parking brak e , tur n the ignition off , and
remo v e the k ey .
2. R emo v e the drain plug from the right side of
the reser v oir ( Figure 48 ) and let the fluid flo w
into a drain pan. Install and tighten the plug
when the fluid stops draining .
Note: Dispose of the used oil at a cer tified
recycling center .
37