Installation Instructions

FormNo.3375-669RevA

TrashBagKit

GrandStand

Mower

ModelNo.121-6039

InstallationInstructions

Thiskitcanbeinstalledoneithersideofthemachine.

InstallingitontheleftsideallowsforinstallationoftheChute

GateKitontherightside.Twokitscanbeinstalled,oneon

theleftandoneontheright.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Bracket1

Thread-formingbolt(3/8x1inch)

Installthebagbrackettothemower

Cupholder

Bolt(#10x5/8inch)

FlatWasher2

Locknut(#10)

Installthecupholder

Trashbag1Installthetrashbag

InstallingtheBrackettothe

Mower

Partsneededforthisprocedure:

1Bracket

Thread-formingbolt(3/8x1inch)

Procedure

Installthebrackettothesideofthemachinewith2

thread-formingbolts(3/8x1inch).

Figure1

1.Leftsideofmachine3.Thread-formingbolt,(3/8x

1inch)

2.Bracket

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3375-669*A

PAGE 1
Form No. 3375-669 Rev A Trash Bag Kit GrandStand® Mower Model No. 121-6039 Installation Instructions This kit can be installed on either side of the machine. Installing it on the left side allows for installation of the Chute Gate Kit on the right side. Two kits can be installed, one on the left and one on the right. Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 Description Use Qty.
PAGE 2
3 Installing the Cup Holder Installing the Trash Bag Parts needed for this procedure: Parts needed for this procedure: 1 1 Cup holder 2 Bolt (#10 x 5/8 inch) 2 Flat Washer 2 Locknut (#10) Trash bag Procedure Install the trash bag into the slots in the bag bracket (Figure 3). Procedure Install the cup holder to the bag bracket with 2 bolts (#10 x 5/8 inch), 2 washers, and 2 locknuts (#10) (Figure 2). Position the washers between the bracket and the bolts. Figure 3 1. Bracket Figure 2 1.