Installation Instructions

ManualsBrandsToro ManualsLawn MowersToro 125-5064

FormNo.3376-352RevA

MulchingKit

30inTurfMasterWalk-BehindLawnMower

ModelNo.125-5064

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Mulchbafeassembly

Carriagebolt(5/16x3/4inch)

Flangelocknut(5/16inch)

Flange-headbolt(1/4x1/2)

Installthemulchingkit.

Nopartsrequired

–

Converttoside-dischargeoperation(asneeded).

InstallingtheMulchingKit

WARNING

Ifyouleavethewireonthesparkplug,someone

couldaccidentallystarttheengine.Accidental

startingoftheenginecouldseriouslyinjureyouor

otherbystanders.

Disconnectthewirefromthesparkplugbeforeyou

doanymaintenance.Setthewireasidesothatit

doesnotaccidentallycontactthesparkplug.

Note:Determinetheleftandrightsidesofthemachine

fromthenormaloperatingposition.

1.Parkthemachineonalevelsurface.

2.Makesurethatallmovingpartshavestoppedandthe

machinehascooled.

3.Removethespark-plugwirebeforestartingthese

instructions.

4.Removethegrassbagorsidedischargechutefromthe

machine,whicheveryourmachineiscurrentlyequipped

with,alongwithitshardware.

5.Tiptheunitontoitsrightside.

6.Cleanoutanygrassbuildupfromundersideofdeck.

7.Removeandretaintheowcontrolbafefromthe

frontofthedeck(Figure1)andhardware.

g021232

Figure1

Removingoriginalhardware

1.Nut

3.Carriagebolt

2.Flowcontrolbafe

8.InstallthemulchbafeassemblyasshowninFigure2.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3376-352*A

Summary of content (2 pages)

PAGE 1
Form No. 3376-352 Rev A Mulching Kit 30in TurfMaster Walk-Behind Lawn Mower Model No. 125-5064 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Mulch baffle assembly Carriage bolt (5/16 x 3/4 inch) Flange locknut (5/16 inch) Flange-head bolt (1/4 x 1/2) 1 3 4 1 Install the mulching kit. No parts required – Convert to side-discharge operation (as needed).
PAGE 2
1 Converting to Side-Discharge Operation 1 To convert the mower back to side-discharge operation, complete the following procedure: 1. Park the machine on a level surface. 2. Make sure that all moving parts have stopped and the spark plug wire has been disconnected. Note: Allow the unit to cool before starting these instructions. 3. Remove the bagger from the unit if equipped. 4. Tip the unit rearward onto its handle. 4 2 5. Clean out any grass buildup from underside of deck. 2 3 6.