Installation Instructions

FormNo.4502-881RevA

ROPSKit

KitNo.126-9525and126-9526

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ItemPartNo.Description

Qty

—

Wld-ROPSLegRH

—

Wld-ROPSLegLH

3126-7838

Asm-ROPSUpperW/Decal

3:2107-3069

Decal-WarningFoldingROPS

4116-0104

Asm-SpringPin

126-9209

Bolt-ROPSShoulderPivot

699-5107

Nut-Lock1/2-13

109-9233Bumper-RubberPush-In2

8126-9966

Bumper-ROPS

9126-9488

Screw-HHF5/8-11X31/2Gr8

1032128-50

Nut-Hex5/8-11Whizlock

12119-4164Washer-Wave2

Figure1

OriginalInstructions(EN)PrintedintheUSA

AllRightsReserved

*4502-881*A

PAGE 1
Form No. 4502-881 Rev A ROPS Kit Kit No. 126-9525 and 126-9526 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Loose Parts Use the chart below to verify that all parts have been shipped. Item Part No.
PAGE 2
Safety Alert Symbol WARNING There is no rollover protection when the roll bar is down. Wheels dropping over edges, ditches, steep banks, or water can cause rollovers, which may result in serious injury, death or drowning. This Safety Alert Symbol (Figure 2) is used both in this instruction sheet and on the machine to identify important safety messages which must be followed to avoid accidents This symbol means: ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! • Do Not remove the ROPS.
PAGE 3
Removing the Existing Rollover Protection System (ROPS) 7. Reconnect the negative battery cable. Check Rollover Protections Systems (Roll Bar) Knobs 1. Disconnect the negative battery cable. Service Interval: Before each use or daily 2. Remove and discard the upper ROPS tube and its hardware from the lower legs. Check that both the mounting hardware and the knobs are in good working condition. Make sure the knobs are fully engaged with the ROPS in the raised position.