Installation Instructions

FormNo.3378-645RevA

BagKit

SandPro

2040ZTractionUnit

ModelNo.127-0359

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Bagbracket1

Threadformingscrew,5/16x1/2inch

InstallthebagbrackettotheROPS

Trashbag1Installthetrashbag

MediaandAdditionalParts

Description

Qty.

Use

Installationinstructions1

Readinstructionsbeforeinstallingandoperatingthekit

Partscatalog1

Usetoreferencepartnumbers

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3378-645*A

PAGE 1
Form No. 3378-645 Rev A Bag Kit Sand Pro® 2040Z Traction Unit Model No. 127-0359 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description 1 2 Use Qty.
PAGE 2
1 1 2 3 Installing the Bag Bracket Parts needed for this procedure: 1 Bag bracket 2 Thread forming screw, 5/16 x 1/2 inch Procedure 1. Align the bag bracket mounting holes with the holes in the right post of the ROPS. Position the bracket on the ROPS as shown in Figure 1. 1 G023526 Figure 2 1. Trash bag rod 3. Slots in bag bracket 2. Hem on trash bag 2. Install the trash bag rod ends into the slots in the bag bracket (Figure 2). 2 G023525 Figure 1 1. Bag bracket 2.