Installation Instructions

FormNo.3382-204RevA

SplashGuardKit

2010andAfterWorkman

MDorMDXUtilityVehicle

ModelNo.127-7377

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

InstallingtheAir-cleaner

Shield

1.Usingtheair-cleanershieldasthetemplate,drill3holes

(4.8mm(3/16inch)indiameter)intotheenginetray

(Figure1).

Figure1

1.Enginetray2.Air-cleanershield

2.Aligntheair-cleanershieldwiththe3holesinthe

enginetray.

3.Securetheair-cleanershieldtotheenginetraywith3

tekscrews(1/4inch)asshowninFigure2.

Figure2

1.Enginetray

3.Tekscrews(1/4inch)

2.Air-cleanershield

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3382-204*A

PAGE 1
Form No. 3382-204 Rev A Splash Guard Kit 2010 and After Workman® MD or MDX Utility Vehicle Model No. 127-7377 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installing the Air-cleaner Shield 3. Secure the air-cleaner shield to the engine tray with 3 tek screws (1/4 inch) as shown in Figure 2. 1.
PAGE 2
Installing the Clutch Shield 1. Using the clutch shield as the template, drill 4 holes (4.8 mm (3/16 inch) in diameter) into the engine tray (Figure 3). Figure 3 1. Engine tray 2. Clutch shield 2. Align the clutch shield with the 4 holes in the engine tray. 3. Secure the clutch shield to the engine tray with 4 tek screws (1/4 inch) as shown in Figure 4. Figure 4 1. Engine tray 3. Tek screws (1/4 inch) 2.