Installation Instructions

ManualsBrandsToro ManualsTrench RollerToro 127-7527

FormNo.3394-287RevA

GlowPlugKit

TR-34DTrenchRoller

ModelNo.127-7527

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Forambientairtemperaturesof7°C(45°F)andbelow,theglowplugisrecommendedforstartingtheTrenchRoller.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Glowplug

Washers2

Nut1

Cableties

Glow-plugwiringharness

Relayswitch1

Spacer

Wiringharness1

Installtheglowplugkit.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3394-287*A

Summary of content (4 pages)

PAGE 1
Form No. 3394-287 Rev A Glow Plug Kit TR-34D Trench Roller Model No. 127-7527 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. For ambient air temperatures of 7°C (45°F) and below, the glow plug is recommended for starting the Trench Roller. Installation Loose Parts Use the chart below to verify that all parts have been shipped.
PAGE 2
Installing the Glow Plug Kit Preparing the Machine 1. Set the parking brake, open the hood panels, and remove the right-side panel; refer to the Owner’s Manual of the machine. 2. Disconnect the battery. g024025 Figure 2 Routing the Wiring Harness 1. Remove the wire connector from the rear of the ignition switch. 5. Remove the bolt on the right side of the engine (Figure 3). 2. Install the non-insulated terminal of the long wire to pocket 8 of the connector (Figure 1).
PAGE 3
Installing the Glow Plug 1 1. Remove the plug fitting at the front of the intake manifold of the engine (Figure 5). 2 3 5 4 g023996 Figure 4 1. Longest wire on the 4. Connector on the glow-plug wiring harness glow-plug wiring harness connected to the glow plug connected to the connector of the wire that is routed to the rear of the ignition switch 2. Location to install the medium wire on the glow-plug wiring harness 5. Connector on wire being routed from the ignition switch g023993 Figure 5 3.
PAGE 4
Operation Starting the Machine 1. Turn the key to the Run position and wait for the voltage that is displayed on the screen to drop and raise back up (Figure 7). 1 6 2 3 4 7 5 g028261 Figure 7 1. Information 2. Off 5. Start 6. Key switch 3. Run 7. Key 4. Glow-plug / preheat location 2. Turn and hold the key in between the Run and Start positions for 45 seconds (Figure 7). Note: The display will shut off after 10 seconds but the preheater will continue to function.