Installation Instructions

ManualsBrandsToro ManualsAttachments, Parts & AccessoriesToro 130-0788

FormNo.3383-508RevA

SeatKit

TITAN

Zero-Turn-RadiusRidingMower

ModelNo.130-0788

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

Thisproductcontainsachemicalorchemicals

knowntotheStateofCaliforniatocausecancer,

birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Removetheseatandtheseatbelt.

Seat

Seatsupport

Bolt(threadforming)(1/4x1/2inch)

Flangenut(3/8inch)

Seatlatch

Shoulderbolt(3/8x1-1/8inch)

Spring

Installtheseat.

Nopartsrequired

–

Testthesafetyinterlocksystem.

RemovingtheSeatandthe

SeatBelt

NoPartsRequired

Procedure

1.Tilttheseatup.

2.Unplugtheharnessconnectorfromtheseatswitch

locatedundertheseat(

Figure1).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3383-508*A

Summary of content (4 pages)

PAGE 1
Form No. 3383-508 Rev A Seat Kit TITAN® Zero-Turn-Radius Riding Mower Model No. 130-0788 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Remove the seat and the seat belt.
PAGE 2
1 Installing the Seat 2 Parts needed for this procedure: g025204 Figure 1 1. Existing seat switch 2. Use this connector for the new seat switch 1 Seat 1 Seat support 2 Bolt (thread forming) (1/4 x 1/2 inch) 2 Flange nut (3/8 inch) 1 Seat latch 2 Shoulder bolt (3/8 x 1-1/8 inch) 1 Spring Procedure 3. At the seat pivot, remove the hairpin cotter pins and rod at the seat hinge. Retain the hairpin cotter pins and rod for installing the new seat. 1.
PAGE 3
Testing the Safety Interlock System No Parts Required Figure 4 1. Spring installed 2. Seat latch Procedure CAUTION 4. Install the seat support to the frame of the machine with 2 thread-forming bolts (1/4 x 1/2 inch) (Figure 5). 5. Torque the thread-forming bolts to 5.2 to 6.8 N-m (46 to 60 in-lbs). If safety interlock switches are disconnected or damaged the machine could operate unexpectedly causing personal injury. 6.
PAGE 4
Operation Positioning the Seat The seat can move forward and backward. Position the seat where you have the best control of the machine and are most comfortable. To adjust, move the lever sideways to unlock seat (Figure 6). g024881 Figure 6 Changing the Seat Suspension The seat is adjustable to provide a smooth and comfortable ride. Position the seat where you are most comfortable. To adjust it, turn the knob in front either direction to provide the best comfort (Figure 7).