Installation Instructions

ManualsBrandsToro ManualsVehiclesInterior Mirror Kit, Workman Utility Vehicle

FormNo.3424-489RevA

InteriorMirrorKit

Workman

UtilityVehicle

ModelNo.130-5449

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Mirrorassembly1

Phillips-headscrew(#10x5/8inch)

Installthemirror(forGTXmodelswithacanopy—Model

07921or07922).

Mirrorassembly1

Phillips-headscrew(#10x5/8inch)

Installthemirror(forGTXmodelswithacab—Model

07142,2-personcanopy—Model07140,4-person

canopy—Model07141,orMD/MDE/MDX/HDXmodels).

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Shutofftheengineandremovethekey.

g038494

Figure1

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3424-489*A

Summary of content (4 pages)

PAGE 1
Form No. 3424-489 Rev A Interior Mirror Kit Workman® Utility Vehicle Model No. 130-5449 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine. Mirror assembly Phillips-head screw (#10 x 5/8 inch) Mirror assembly 1 2 1 Phillips-head screw (#10 x 5/8 inch) 2 Install the mirror (for GTX models with a canopy—Model 07921 or 07922).
PAGE 2
Installing the Mirror For GTX Models with Canopy Model 07921 or 07922 1. Apply medium-grade thread-locking compound to the 2 Phillips-head screws (#10 x 5/8 inch). 2. Secure the mirror assembly to the canopy support bracket using the 2 Phillips-head screws (#10 x 5/8 inch) as shown in Figure 2. g258866 Figure 2 1. Canopy support bracket 3. Phillips-head screw (#10 x 5/8 inch) 2.
PAGE 3
Installing the Mirror For GTX Models with Cab (Model 07142), 2-Person Canopy (Model 07140), 4-Person Canopy (Model 07141), or MD/MDE/MDX/HDX Models 1. Apply medium-grade thread-locking compound to the 2 Phillips-head screws (#10 x 5/8 inch). g035629 Figure 4 Workman GTX Shown Note: If you have a GTX machine, remove the 2 plastic plugs from the upper cab frame before installing the mirror assembly (Figure 3). 1. Hole (upper cab frame) 3. Phillips-head screws (#10 x 5/8 inch) 2.
PAGE 4
Operation Adjusting the Mirror Important: Adjust the viewing angle of the mirror before you drive the machine. 1. Use 2 hands to rotate the mirror up or down on its ball mount (A of Figure 6 or Figure 7). g035628 Figure 7 Workman MD/MDE/MDX/HDX Shown g035630 Figure 6 Workman GTX Shown 2. 4 Use 2 hands to rotate the mirror left or right on its ball mount (B of Figure 6 or Figure 7).