Installation Instructions

ManualsBrandsToro ManualsRiding ProductsCanopy Completion Kit, Groundsmaster 4300-D or Reelmaster 5410/5510/5610 Traction Unit with ROPS

FormNo.3394-944RevA

CanopyCompletionKit

Groundsmaster

4300-DorReelmaster

5410/5510/5610Traction

UnitwithROPS

ModelNo.130-5895

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Rearbracket1Installtherearbracket.

Frontbracket2

Carriagebolt

Flangenut2

Installthefrontbrackets.

Grommet

Flange-headbolt4

Washer8

Flangenut4

Installthecanopy.

MediaandAdditionalParts

Description

Qty.

Use

Installationinstructions1

Readtheinstructionsbeforeinstallingthekit.

Partscatalog1

Usethecatalogtoreferencepartnumbers.

InstallingtheRearBracket

1.Parkthemachineonalevelsurface.

2.Stoptheengine,engagetheparkingbrake,andremove

thekeyfromtheignitionswitch.

3.Loosentheexisting3angenutssecuredtothe3

carriageboltsonthecanopyframe(Figure1).

Figure1

1.Rearbracket

3.Existingangenut(3)

2.Existingcarriagebolt(3)

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3394-944*A

Summary of content (2 pages)

PAGE 1
Form No. 3394-944 Rev A Canopy Completion Kit Groundsmaster® 4300-D or Reelmaster® 5410/5510/5610 Traction Unit with ROPS Model No. 130-5895 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty.
PAGE 2
4. Position the rear bracket so that the 3 existing carriage bolts fit into the 3 slots in the bracket (Figure 2). 2. Position the canopy as shown in Figure 5. Figure 2 1. Rear bracket 5. Tighten the flange nuts to secure the bracket. Installing the Front Brackets 1. Position a front bracket as shown in Figure 3. Figure 5 1. Flange-head bolt (4) 3. Canopy 2. Washer (8) 4. Flange nut (4) 3. Secure the canopy with 4 flange-head bolts, 8 washers, and 4 flange nuts (Figure 6). Figure 3 1.