Installation Instructions

FormNo.3384-930RevA

ReplacementCableKit

2012and2013TimeMaster30inLawnMowers

ModelNo.130-6739

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

1.Removetheoldself-propelcableanddiscardit.

2.Drillanddeburra16mm(5/8inch)diameterholein

themowerhousinginthelocationshownin

Figure1.

Figure1

1.Drillanddeburra16mm

(5/8inch)diameterhole

here.

2.Smallhole(hasaboltin

ittoretainthefuseholder

onelectric-startmodels)

Note:Thecenterofboththedrilledholeandthe

smallerholeshouldbethesamedistancefromtheleft

edgeofthemowerframe.Onelectric-startmodels,

thereisaboltinthesmallholetoretainthefuseholder.

3.Insertthenewcablefromthetop(springendrst)

throughthedrilledhole.

4.Attachthecablespringendontothetransmission

activationleverasshowninFigure2.

Figure2

1.Transmissiongearbox3.Transmissionactivation

lever

2.Cablespringend

5.Insertthecableanchorintotheholeinthebracketon

thetransmissioncaseasshowninFigure3.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3384-930*A

PAGE 1
Form No. 3384-930 Rev A Replacement Cable Kit 2012 and 2013 TimeMaster 30in Lawn Mowers Model No. 130-6739 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. 1. Remove the old self-propel cable and discard it. 2. Drill and deburr a 16 mm (5/8 inch) diameter hole in the mower housing in the location shown in Figure 1. edge of the mower frame.
PAGE 2
Figure 5 10. Pull the cable jacket down (toward the machine) until there is no slack in the cable (Figure 6). Figure 3 2. Transmission case 1. Cable anchor 6. Route the cable upward along the left side of the handle as shown in Figure 4. Figure 6 11. Tighten the nut on the cable support. Figure 4 1. Self-propel-drive cable 2. Drilled hole 7. Secure the upper end of the cable to the traction lever. 8. Pull the upper handle all the way up. 9. Loosen the cable-support nut (Figure 5).