Installation Instructions

FormNo.3383-520RevA

ROPSConversionKit

TITAN

Zero-Turn-RadiusRidingMower

ModelNo.130-6850

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Pivotbracket4

Rubberbumper2

Spacer

Roundspacer2

Pinassembly2

Nut(5/16inch)

InstalltheROPSParts

InstallingtheROPSParts

1.RemovetheexistingsidebracketsontheROPS.Save

thenutsandboltsforinstallingthenewbrackets.

2.Installtherubberbumperstothelowerpartofthe

ROPSwith2nuts(5/16inch)(Figure1).

3.Installthepivotbracketsandspacerstotheupperpart

oftheROPSwiththepreviouslyremovednutsand

bolts(

Figure1).

4.InstalltheupperpartoftheROPS,roundspacer,and

pinassemblytothelowerpartoftheROPSwiththe

previouslyremovednutsandbolts(Figure1).

5.Torqueallnutsandboltsto40.7to49.7N-m(360to

440in-lb).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3383-520*A

PAGE 1
Form No. 3383-520 Rev A ROPS Conversion Kit TITAN® Zero-Turn-Radius Riding Mower Model No. 130-6850 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty.
PAGE 2
Figure 1 1. Upper part of the ROPS 5. Washer 2. Rubber bumper 6. Bolt 3. Spacer 7. Round spacer 4. Pivot bracket 8. Pin assembly 9. Lower part of the ROPS 10.
PAGE 3
Operation 3. Install the locking pins. Secure the pins by installing the hair cotter pin (Figure 3). G015035 Using the Rollover Protection System (ROPS) 2 1 2 WARNING To avoid injury or death from rollover: keep the roll bar in the raised locked position and use the seat belt. 3 Figure 3 1. Hole in ROPS WARNING 3. Hair pin cotter 2. Locking pin There is no rollover protection when the roll bar is in the down position. • Lower the roll bar only when absolutely necessary.
PAGE 4