Installation Instructions

FormNo.3394-879RevA

StepKit

Multi-Pro5800TurfSprayer

ModelNo.130-8230

ModelNo.130-8231

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Figure1

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Spacerbracket

Stepmount(Model130-8231)

Hex-headbolt(1/2x6inch)

Locknut(1/2inch)

Washer(1/2inch)

Installtheleftstepmount.

Spacerbracket

Stepmount(Model130-8230)

Hex-headbolt(1/2x6inch)

Locknut(1/2inch)

Washer(1/2inch)

Installtherightstepmount.

Step

Hex-headbolt(1/4x2-1/4inch)

Flangenut(1/4inch)

Washer(1/4inch)

Installthestep.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3394-879*A

PAGE 1
Form No. 3394-879 Rev A Step Kit Multi-Pro 5800 Turf Sprayer Model No. 130-8230 Model No. 130-8231 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Figure 1 Installation Loose Parts Use the chart below to verify that all parts have been shipped.
PAGE 2
1 2 Installing the Left Step Mount (Model 130-8231) Installing the Right Step Mount (Model 130-8230) Parts needed for this procedure: Parts needed for this procedure: 1 Spacer bracket 1 Spacer bracket 1 Step mount (Model 130-8231) 1 Step mount (Model 130-8230) 1 Hex-head bolt (1/2 x 6 inch) 1 Hex-head bolt (1/2 x 6 inch) 1 Locknut (1/2 inch) 1 Locknut (1/2 inch) 1 Washer (1/2 inch) 1 Washer (1/2 inch) Procedure Procedure 1.
PAGE 3
Installing the Step (Model 130-8230 or 130-8231) Parts needed for this procedure: 1 Step 2 Hex-head bolt (1/4 x 2-1/4 inch) 2 Flange nut (1/4 inch) 2 Washer (1/4 inch) Procedure 1. Align the 2 holes in the step with 2 of the holes in the end of the step mount (Figure 3). Note: You can install the step in 1 of 5 positions to best suit your preference. Note: Use the outer-hole position when the machine is equipped with the cab option. Figure 3 1. Hex-head bolts (1/4 x 2-1/4 inch) 4. Step 2.
PAGE 4