Installation Instructions

6
InstallingtheBladeArms
Partsneededforthisprocedure:
1
Lift-armassembly
2
Pin(1-1/2x5-1/4inch)
4
Snapring(1-3/8inch)
1
Liftcylinder—retractedlength51.4cm(20.25inch);
roddiameter38.1mm(1.5inch)
2
Clevispin(1-1/4x4-7/16inch)
2Hairpin
InstallingtheLiftArms
Liftarmweight:84kg(185lb)
1.Install2snaprings(1-3/8inch)ontotheendofthe2
pins(1-1/2x5-1/4inch)asshowningureFigure30.
Figure30
1.Snaprings(1-3/8inch)2.Pins(1-1/2x5-1/4inch)
2.Supportthelift-armassemblywithliftingequipment
witha84kg(185lb)capacity.
3.Alignthettingsattheendoftheliftarmswiththelift
angesofthepivotframe(Figure31).
Figure31
1.Fitting(lift-armassembly)3.Liftange(pivotframe)
2.Snaprings(1-3/8inch)4.Pins(1-1/2x5-1/4inch)
4.Aligntheholesinthettingswiththeholesinthe
anges(Figure31).
5.Insertapin(1-1/2x5-1/4inch)throughtheholesin
thettingandangesat1sideofthemachine(Figure
31).
6.Securethepinwithasnapring(1-3/8inch)asshown
inFigure31.
7.Repeatsteps5and6forthettingandangesonthe
othersideofthemachine.
8.Aligntheliftarmslevelandsupportthemwithjack
standswitha263kg(580lb)capacity.
13