Installation Instructions

ManualsBrandsToro ManualsTrenchersToro 131-2813

FormNo.3395-439RevA

TransmissionFilterKit

RT1200TractionUnit

ModelNo.131-2813

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Filter1

Changethetransmissionlter.

Nopartsrequired

–

Checkthetransmissionlterforleaks.

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Lowerallattachments,stoptheengine,andremove

thekey.

3.Removetheright-sidepanel;refertoOperator’sManual

forthemachine.

4.RotatetheBATTERY-DISCONNECTswitchtotheOff

position;refertoOperator’sManualforthemachine.

5.Allowthemachinetocool10to20minutes.

ChangingtheTransmission

Filter

ChangingtheFilter

Note:Youcanaccessthetransmissionlterfromunderneath

therightsideofthemachine,inboardofthehydraulictank.

1.Placeadrainpanunderthetransmission-oillter

(Figure1).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3395-439*A

Summary of content (4 pages)

PAGE 1
Form No. 3395-439 Rev A Transmission Filter Kit RT1200 Traction Unit Model No. 131-2813 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine. Filter 1 Change the transmission filter.
PAGE 2
Checking the Oil Level in the Transmission Specified transmission oil: Mobilfluid 424 Important: If you operate the machine while the level of the transmission oil is below the recommended level, you may damage the transmission and the parking brake. 1. Rotate the BATTERY -DISCONNECT switch to the On position; refer to Operator’s Manual for the machine. 2. Start the engine and run it for 10 minutes. 3. Stop the engine and remove the ignition key. 4. Check the transmission filter and filter head for leaks.
PAGE 3
Figure 3 1. Oil-servicing equipment 3. Fill plug 2. Fill port B. Clean the threads of the plug. C. Apply PTFE thread sealing tape to the threads of the plug. D. Fill the transmission with the specified oil through the fill port until the oil level covers 1/2 to 3/4 of the sight-gauge window (Figure 2 and Figure 3). Important: When you fill the transmission with oil, slowly add the oil into the transmission to avoid entraining air with the oil. E.
PAGE 4