Installation Instructions

Figure46
1.Leftcowlpanel3.Hood-plateange
2.Flange-headbolt(12x40
mm)
4.ROPS-mountingplate
4.Aligntheholesintheangeattherearframetubefor
theROPSwiththeholesintheROPSmountforthe
chassisofthemachine(Figure47).
Note:Ifyouhavedifcultyaligningtheholes,usea
hand-operatedwinchbetweentherearROPStubeand
afrontROPStubetopulltherearROPStubeforward
andaligntheholes.Usethehand-operatedwinch
betweentherearROPStubestopullthetubesinward
toaligntheholes(Figure47).
Figure47
1.Flangelocknuts(16mm)3.ROPStube
2.Flange-headbolts(16x
70mm)
5.AssembletherearROPStubetothechassiswith4
ange-headbolts(16x70mm)and4angelocknuts
(16mm),andtightenbyhand(Figure47).
6.Repeatsteps4and5totherearROPStubeattheother
sideofthemachine.
7.Torquetheboltsandnutsasindicatedinthetablethat
follows:
DescriptionTorquevalue
Flange-headbolts(16x50
mm)andangelocknuts
(16mm)—ROPSplateand
consoleframe(Figure45)
319to400N-m(235to295
ft-lb)
Flange-headbolts(12x40
mm)—hoodplate,ROPS
plate,leftandrightcowlpanel
(Figure46)
80to10N-m(59to73ft-lb)
Flange-headbolts(16x70
mm)andangelocknuts(16
mm)—rearROPStubesand
chassis(Figure47)
319to400N-m(235to295
ft-lb)
InstallingtheRearFenders
andtheRearControlCover
InstallingtheRearFenders
1.Applyacoatofmedium-grade,thread-locking
compoundtothethreadsofthe10ange-headbolts
(10x30mm)thatyouremovedinsteps1and3of
RemovingtheRearFenders(page13).
2.Aligntheholesintherearfenderwiththeholesinthe
fendermountofthechassisandangeoftheROPS
tube(Figure48).
Note:Haveanotherpersonsupporttherearfender
whileyouinstallthemountinghardware.
Figure48
1.Flange-headbolts(10x
30mm)
4.Straightreinforcement
plateandclipnuts
2.Curvedreinforcement
plateandclipnuts
5.Fender
3.Fendermount
6.Frontofthemachine
18