Installation Instructions

Figure62
1.Upperedgeofthe
upper-weldseam
3.Loweredgeofthe
lower-weldseam
2.152.4mm(6inches)
2.Attherightsideofthebellows,measurethedistance
fromtheupperedgeoftheupper-weldseamtothe
loweredgeofthelower-weldseam.
Recordyourmeasurementhere:
Note:Ifyourrightsidemeasurementislessthanor
greaterthan152.4mm(6inches)andthepleatsofthe
bellowsarenotverticallyaligned,performthestepsin
AligningtheMuferLefttoRight(page24).
3.Ifthefrontandsidemeasurementsofweldseamsfor
thebellowsare152.4mm(6inches)andthepleatsof
thebellowsareverticallyaligned,skiptoSecuringthe
Turbocharger-ExhaustPipe(page24).
AligningtheMuferFronttoBack
1.Loosenthe4ange-headbolts(8x120mm)and
angelocknuts(8mm)thatsecuretheexhaust-system
mounttotheROPStube(Figure63).
Figure63
1.ROPStube4.Shim0.76mm(0.03inch)
2.Exhaust-systemmount
5.Shim1.52mm(0.06inch)
3.Flange-headbolts(8x120
mm)—lowerpositions
2.Addshim(s)—fromtheshippingkitorremovethe
shim(s)totheexhaust-systemmountatthelower2
ange-headboltsasneededtoalignthepleatsofthe
bellows(Figure63).
Note:Changethetotalshimthicknessin0.76mm
(0.03inch)increments.
3.Torquetheange-headboltsandangelocknutsfor
theexhaust-systemmountto17to21N-m(23to29
ft-lb).
4.Measurethebellowsweld-seamdimensionandconrm
thatthepleatsofthebellowsarealignedstraight
(Figure62).
Note:Ifbellowsisnotaligned,repeatsteps1through
3untiltheweld-seamsmeasurementforthebellowsis
152.4mm(6inches)fronttobackandthepleatsofthe
bellowsarealignedstraight.
5.Iftheturbocharger-exhaustpipeisalignedlefttoright,
skiptoSecuringtheTurbocharger-ExhaustPipe(page
24).
23