Installation Instructions

2
InstallingtheKit
Partsneededforthisprocedure:
8
Capscrew(1/4x1-1/4inches)
11
Nut(1/4inch)
1
Controller
1
RF2CANcontroller
1
Screw(#10)
1Locknut
1
Cover
1Relay
1
Bolt(1/4x3/4inch)
1Light
Procedure
1.Drill13holesintothefenderguard;refertoFigure4
fortheappropriateholelocationsanddiameter.
Note:DonotdrillItem11inFigure4oversizedas
thewireharnesswillnotholdwithclipsprovided.
g035615
Figure4
1.10.26cm(4.04inches)7.17.98cm(7.08inches)13.13.77cm(5.42inches)
2.0.71cm(0.28inch)diameter(4x)8.19.91cm(7.84inches)14.9.32cm(3.67inches)
3.8.46cm(3.33inches)9.10.54cm(4.15inches)15.6.68cm(2.63inches)
4.1.29cm(0.51inch)10.13.06cm(5.14inches)16.12.04cm(4.74inches)
5.1.07cm(0.42inch)11.0.68cm(0.266inch)diameter(5x)17.0.71cm(0.28inch)diameter(4x)
6.21.21cm(8.35inches)12.1.91cm(0.75inch)
5