Installation Instructions

Instructions: Tractor Seat Cover
Installation
Your seat cover has storage pockets on the back of the cover. This
side faces back.
If your seat has armrests, lift the armrests into the vertical position.
Pull the seat cover over the seat back while inserting armrests
through the side holes. Then pull the
rest of the cover over the seat front.
If your seat does not have armrests,
simply pull the seat cover over the seat
back. Then pull the rest of the cover
over the seat front.
Cleaning and Care
Clean your cover with a soft brush
and lukewarm water. DO NOT USE
SOAP as it may remove the protective
coatings added by the factory. Line
dry or machine dry on air or delicate settings only. Do not dry on
high heat as it could melt the foam in the cover.
Storage
To avoid any possibility of mildew be sure your seat cover is
completely dry before you store it in an enclosed area for a long
period.
Toro General Commercial Parts Warranty
A Ninety-Day Limited Warranty
Conditions and Products Covered
The Toro Company and its affiliate, Toro Warranty Company,
pursuant to an agreement between them, jointly warrant your Toro
Commercial parts (“Part”) to be free from defects in materials or
workmanship for ninety (90) days.
Where a warrantable condition exists, we will repair or replace the
part at no cost to you. This warranty begins on the date the Part is
purchased by the original retail purchaser.
Instructions for Obtaining Warranty Service
You are responsible for notifying the Commercial Products
Distributor or Authorized Commercial Products Dealer from whom
you purchased the Product as soon as you believe a warrantable
condition exists. If you need help locating a Commercial Products
Distributor or Authorized Dealer, or if you have questions regarding
your warranty rights or responsibilities, you may contact us at:
Toro Commercial Products Service Department
Toro Warranty Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
952-888-8801 or 800-982-2740
E-mail: [e-mail]
Items and Conditions Not Covered
Not all product failures or malfunctions that occur during the
warranty period are defects in materials or workmanship. This
warranty does not cover the following:
• Part failures which result from the use of non-Toro
replacement parts, or from installation and use of add-on,
or modified non-Toro branded accessories and products. A
separate warranty may be provided by the manufacturer of
these items.
• Part failures which result from failure to perform recommended
maintenance and/or adjustments. Failure to properly maintain
your Toro product per the recommended maintenance listed in
the Operator’s Manual can result in claims for warranty being
denied.
• Part failures which result from operating the Product in an
abusive, negligent or reckless manner.
• Parts subject to consumption through use unless found to be
defective. Examples of parts which are consumed, or used
up, during normal Product operation include, but are not
limited to, brake pads and linings, clutch linings, blades, reels,
rollers and bearings (sealed or greasable), bed knives, aerator
crankshafts and stomper arm bearings, tines, spark plugs,
castor wheels and bearings, tires, filters, belts, and certain
sprayer components such as diaphragms, nozzles, and check
valves, etc.
15cH54_18043
Toro Large, Part #131-6691
Toro Small, Part #131-6690
• Failures caused by outside influence. Conditions considered
to be outside influence include, but are not limited to, weather,
storage practices, contamination, use of unapproved coolants,
lubricants, additives, fertilizers, water, or chemicals, etc.
Normal noise, vibration, and deterioration, “wear and tear”.
Normal “wear and tear” includes, but is not limited to, damage
to seats due to wear or abrasion, worn painted surfaces,
scratched decals or windows, etc.
General Conditions
Repair by an Authorized Toro Distributor or Dealer is your sole
remedy under this warranty.
Neither The Toro Company nor Toro Warranty Company is liable for
indirect, incidental or consequential damages in connection with
the use of the Toro Products covered by this warranty, including
any cost or expense of providing substitute equipment or service
during reasonable periods of malfunction or non-use pending
completion of repairs under this warranty. Except for the Emissions
warranty referenced below, if applicable, there is no other express
warranty. All implied warranties of merchantability and fitness for
use are limited to the duration of this express warranty.
Some states do not allow exclusions of incidental or consequential
damages, or limitations on how long an implied warranty lasts, so
the above exclusions and limitations may not apply to you. This
warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.
Countries Other than the United States or Canada
Customers who have purchased Toro products exported from
the United States or Canada should contact their Toro Distributor
(Dealer to obtain guarantee policies for your country, province, or
state. If for any reason you are dissatisfied with your Distributor’s
service or have difficulty obtaining guarantee information, contact
the Toro importer.
Form No. 3396-657 Rev A