Installation Instructions

ManualsBrandsToro ManualsVehiclesReverse Alarm Kit, Workman GTX Electric Utility Vehicle

FormNo.3403-252RevA

ReverseAlarmKit

Workman

GTXElectricUtilityVehicle

ModelNo.131-8549

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Alarm1Installandconnectthealarm.

Nopartsrequired

–

Connectthebatteries.

Nopartsrequired

–

Testthereverse-alarmfunction.

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurface,settheparking

brake,shutoffthemachine,andremovethekey.

2.Disconnectthemainnegative-batterycable(black)that

connectsthebankofbatteriestothegroundpointof

themachine;refertoyourOperator’sManual.

InstallingandConnectingthe

Alarm

Partsneededforthisprocedure:

1Alarm

Procedure

1.Removetheseatassembly;refertoyourOperator’s

Manual.

2.Raisethecargobox;refertoyourOperator’sManual.

3.Raisethecover-panelleversandremovethecoverpanel

toaccesstheopeningforthealarmintherear-frame

panel(Figure1).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3403-252*A

Summary of content (2 pages)

PAGE 1
Form No. 3403-252 Rev A Reverse Alarm Kit Workman® GTX Electric Utility Vehicle Model No. 131-8549 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 4 Description Qty. Use No parts required – Prepare the machine.
PAGE 2
6. Connect the 2 female connectors on the machine wire harness to the 2 male connectors on the alarm (Figure 4). Note: Connect the red wire to the positive (+) terminal and the black wire to the negative (–) terminal. Figure 1 1. Cover panel 2. Cover-panel levers 4. Unscrew the cap from the alarm (Figure 2). Figure 4 1. Male connector on the alarm 2. Female connector on the machine wire harness 3 Connecting the Batteries Figure 2 1. Cap No Parts Required 2. Alarm Procedure 5.