Installation Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 132-1549

FormNo.3396-687RevA

MuferKit

Grandstand

Mowers

ModelNo.132-1547

ModelNo.132-1548

ModelNo.132-1549

InstallationInstructions

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Mufer

Rightbracket1

Leftbracket

Spacer

Bolt(5/16x1inch)

Nut(5/16inch)

Gasket

Installthekit.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3396-687*A

Summary of content (4 pages)

PAGE 1
Form No. 3396-687 Rev A Muffler Kit Grandstand® Mowers Model No. 132-1547 Model No. 132-1548 Model No. 132-1549 Installation Instructions Note: Determine the left and right sides of the machine from the normal operating position. WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped.
PAGE 2
Installing the Kit 3. Remove the muffler (Figure 3). Note: Retain the 4 nuts (M8), 4 lock washers, and 4 bolts (M8). Kawasaki Engines Removing the Existing Brackets and Muffler 1. Remove the left bracket (Figure 1). Note: Retain the 2 lock washers and 2 bolts (M8). Figure 3 Left side of muffler shown 1. Gasket 4. Nut (M8) 2. Bolt (M8) 5. Muffler 3. Lock washer Figure 1 1. Nut 2. Spacer 4. Lock washer 5. Bolt (5/16 x 1 inch) 3. Bolt (M8) 6. Left bracket Installing the New Muffler and Brackets 1.
PAGE 3
Installing the Kit 3. Remove the muffler (Figure 6). Note: Retain the 4 nuts (M8) and 4 bolts (M8). Kohler Engines Removing the Existing Brackets and Muffler 1. Remove the left bracket. Note: Retain the 3 bolts (M6). Figure 6 Left side of muffler shown 1. Bolt (M8) 3. Nut (M8) 2. Gasket 4. Muffler Installing the New Muffler and Brackets 1. Install the new muffler and 2 new gaskets to the engine using the nuts (M8) and bolts (M8) that you removed from the previous muffler (see Figure 6). Figure 4 1.
PAGE 4