Parts Catalogue

11
0742-850
4. Align the mounting holes in the Roller Fairlead (B) with the lower
mounting holes in the bumper plate and the winch. Secure the roller
fairlead and winch to the bumper plate with the remaining two M8 x 20
cap screws and lock washers. Tighten the four cap screws to 2.8 kg-m
(20 ft-lb).
5. Remove the rubber band retaining the cable onto the reel.
 NOTE: Retain the warning label and winch cable tightening
instructions tied to the cable for future reference.
6. Turn the selector knob to the “freespool” position. Pull the cable loop
through the bumper plate and roller fairlead until the loop is clear of the
roller fairlead (approximately 3-4 in.); then turn the selector knob to the
“ENGAGED” position.
7. Place the clevis end of the tow hook onto the winch cable loop and
secure with the clevis pin; then using a hammer, force the cotter pin
through the clevis pin. The cotter pin will spread automatically. Install
the hook strap.
INSTALLING SOLENOID
 NOTE: Some Prowler models may already have two holes to
mount the solenoid located as shown. If the two holes are
already there in the battery cover, skip steps 1 and 2.
3000 lb winch eng.fm Page 11 Wednesday, August 27, 2014 2:59 PM