Parts Catalogue

12
1. Locate the electrical panel above the battery; then cut out the Two Hole
Template (p/n 0742-852) located at the end of this manual and place it
on top of the electrical panel.
UTV-003
2. Mark the center of the two mounting hole locations; then using a 7 mm
(9/32-in.) drill bit, drill the mounting holes into the panel.
3. Place the solenoid mounting tabs over the mounting holes on the panel
making sure the wire plug on the solenoid is facing toward the engine.
Using two M6 x 25 Torx-Head Machine Screws and M6 Hex Nuts w/
Washers, secure the solenoid to the electrical panel.
 NOTE: Loosening the battery box will aid in the installation of
the solenoid. The battery box does not need to be removed.
4. Connect the Solenoid Adapter Harness to the solenoid.
INSTALLING CONSOLE WINCH SWITCH
1. Remove the right-side plug from the switch panel located above the key
switch on the dash; then insert Winch Switch by applying pressure to
the switch until it snaps into place.
3000 lb winch eng.fm Page 12 Wednesday, August 27, 2014 2:59 PM