Parts Catalogue

7. Connect the adaptor harness to the switch control harness and the sole-

noid. Secure all wires using cable ties.

INSTALLING WINCH CABLES

1. Install a terminal boot over one end of the Blue and the Yellow 106-in.

Cables (solenoid-to-winch). Connect the boot-end of each cable to the

winch motor with the blue cable to the terminal stud marked with a blue

dot. Connect the yellow cable to the yellow stud. Secure with M6 nuts

w/washers; then slide each terminal boot over the terminals.

2. Route the two 106-in. cables across the upper cross-tube on the frame

and to the left-side of the vehicle; then along the top of the left upper-

frame tube. Continue routing the cables downward along the frame tube

to the main switch harness. Continue routing the cables along the har-

nesses to the solenoid. Secure cables and wires with cable ties.

UTV-055

! WARNING

FIRE HAZARD

Failure to observe these instructions could lead to severe injury or

death.

Never route electrical cables:

• Across any sharp edges.

• Through or near moving parts.

• Near parts that get hot.

Always insulate and protect all exposed wiring and electrical terminals.

Always install terminal boots as directed in installation instructions.

3000 lb winch eng.fm Page 15 Wednesday, August 27, 2014 2:59 PM