Parts Catalogue

OPERATING INSTRUCTIONS

CLUTCH OPERATION

When the clutch is engaged, the gear train is coupled to the wire cable drum

and power may be transferred from the winch motor. When the clutch is in

freespool, the gear train and wire cable drum are uncoupled allowing the

drum to rotate freely. The clutch knob, located on the winch housing oppo-

site the motor, controls the clutch position. To prevent damage, always fully

engage or fully disengage the clutch knob.

0742-811A

OVERLOADING/OVERHEATING

This winch is rated for intermittent duty. It should not be operated with the

motor slowed down to a low RPM. When the motor approaches stall speed, a

very rapid heat build-up occurs which may cause motor damage. To judge

safe running time, stop winching and lay your hand on the motor. If the tem-

perature is uncomfortable, shut down and cool the motor. This can be used as

an opportunity to recharge the battery. Double line rigging will reduce the

amperage draw from the motor allowing longer continual use (see Rigging

sub-section).

BATTERY RECOMMENDATIONS

A fully charged battery and good connections are essential to the proper

operation of the winch. A minimum 12 DC volt 10 Amp-hour-rated battery

is required.

MAINTENANCE

• No lubrication is required for the life of the winch.

! WARNING

TO PREVENT SERIOUS INJURY OR PROPERTY DAMAGE:

• Do not disengage clutch if winch is under load or wire cable is in

tension.

3000 lb winch eng.fm Page 4 Wednesday, August 27, 2014 2:59 PM