Parts Catalogue

2
7. Make sure all wires are between the dash and the
gutter of the storage box. Use cable ties to maintain
all wires. See Fig. 4.
Fig. 4
UTV-235A
8. Remove the two machine screws securing the top of the
dash to the frame; route the red wire from the pump to
upper left tab of the switch from the windshield wiper
kit.
9. Route the black wire from the pump to the same mount-
ing location as the black wire from the wiper motor.
Secure the dash to the frame using existing machine
screws. See Fig. 5.
Fig. 5
UTV-236
 NOTE: Cut a 9-in. section of washer tube which
will be routed from the 90° adaptor to the sprayer.
10. Route the washer tube from the pump under the
dash and up along the left-side ROPS tube and
toward the wiper motor.
11. Remove the plug above the wiper motor; then install 90°
Adaptor into the windshield; then connect the washer
tube to the adaptor. See Fig. 6.
Fig. 6
UTV-240A
12. Install Sprayer onto the wiper arm; then plug the
sprayer tube into the 90° adaptor. See Fig. 7.
Fig. 7
UTV-241
13. Fill the tank with appropriate window washer fluid
and test the function of the sprayer.
Printed in the U.S.A. ®™Trademarks of Arctic Cat Inc., Thief River Falls, MN 56701 0711