Parts Catalogue

2
Fig. 3
ROV-051
5. Using a 3/8-in. drill bit, drill all four locations; then
install four Expansion Nuts.
6. On Prowlers without power steering, use a 2 1/4-in.
hole saw and drill two holes in the bottom of the
storage box; then drill a hole in the vertical side of
the storage box below the bottom-left well nut and
through the inner fender panel. See Fig. 4 and 6.
Fig. 4
UTV-132A
Fig. 5
UTV-278A
7. Insert adequate lengths of 2-in. Vent Hose into each
opening; then while holding the heater, attach each
vent hose to the heater flange (shown below) and
secure with three Cable Ties (14 in.). See Fig. 6.
Fig. 6
ROV-372A
8. Secure heater to the storage box using four
machine screws (included in hardware kit).
9. Using a 1-in. hole saw, drill an opening in the stor-
age box left corner; then route Coolant Hose (3/8-
in. x 18-in.) down to lower radiator hose. See Fig.
6.
10. Using two suitable hose clamping devices, clamp
the lower radiator hose in two positions; then cut
the radiator hose. Install Radiator Hose Tee and
secure with three Hose Clamps (3/8 in.). See Fig. 7.
Fig. 7
UTV-126
CAUTION
On power steering models, all three holes will
have to be drilled through the back of the storage
box. Failure to follow this step will result in dam-
age to the electronic power steering assembly.
See Fig. 5 and 6.