Operator's Manual

TT-081

9. Install the mounting bracket on the track assembly

using two M10 x 25 mm cap screws. Tighten to 34

ft-lb.

TT-068

10. Insert the anti-rotation arm into the hole of the

installed mounting bracket.

11. Replace the components removed in step 8 in the

same order.

TT-069

Rear Mounting Brackets (XT and

XTX)

This procedure is appropriate for both left and

right rear track kits.

NOTE: The installation requires that the vehicle

be in 2WD and shifted into neutral.

1. Remove the components from the shipping pack-

age; then verify that there are no missing or dam-

aged components.

2. Place the ROV on a flat surface, and raise the rear

of the ROV using a support stand.

3. Remove the rear wheels; then remove and retain

the rear boot guards.

4. Remove the cap screw and nut securing the lower

A-arm to the rear knuckle assembly; then remove

the cap screw securing the rear suspension bracket.

TT-044

5. Position the rear suspension bracket (A) in place

and loosely secure it using a M10-1.5 x 140 mm

cap screw (B) and the M10 nylon nut (C).

TT-007A

6. Position the M8 U-bolt (D) and secure it using the

two M8 flat washers (E), and two M8 nuts (F).

Tighten the M10 nylon nut to 34 ft-lb and the two

M8 nuts to 17 ft-lb.

7. Repeat steps 1-6 for opposite side.

NOTE: The installation of the anti-rotation arm

must be done before the installation of the track

system on the ROV.

8. From the rear anti-rotation arm assembly, remove

the M16-2.0 nylon nut (A), spring washer (B),

spring (C), spring washer (D) sliding on the steel

slider sleeve, one rubber damper (E), and the

mounting bracket.

TT-081