Operator's Manual

9. Install the mounting bracket on the track assembly

using two M10 x 25 mm cap screws. Tighten to 34

lb-ft).

TT-068

10. Insert the anti-rotation arm into the hole of the

installed mounting bracket.

11. Replace the components removed in step 8 in the

same order.

TT-069

Rear Track Kits

1. Identify which frame corresponds to the wheel

removed using the color images (from page 9).

TT-070

NOTE: Clean the wheel and hubs before install-

ing wheels or track kits.

2. Align the wheel studs with the holes in the track

assembly; then secure the track assembly using

new provided Wheel Lug Nuts. Tighten the lug

nuts in a criss-cross pattern in three steps to 80 ft-

lb.

TT-013

3. Insert the rod end of the anti-rotation arm into the

M12 carriage bolt of the A-arm bracket; then

secure using M12 nut. Tighten to 61 ft-lb.

TT-016

NOTE: It may be necessary to move the track

frame around to align the hole and the carriage

bolt.

4. Repeat steps 1-3 for opposite side.

CAUTION

Care must be taken that the front left track kit is

installed on the left side and the front right track kit

is installed on the right side (see color-coded sticker

for proper identification).