Operator's Manual
14
Snow Deflector Panel Kit (p/n
1541-131)
NOTE: This kit is recommended for use in snow
conditions only.
1. Place the deflector panels in position and secure
with cable ties as needed.
TT-091
TT-092
Adjusting Components
Front Track Toe-In
NOTE: Adjustments can be made by the ROV
owner if qualified to do so. If the owner does not
feel qualified, take the ROV to an authorized Arctic
Cat ROV dealer for this service at the expense of
the owner/operator.
NOTE: This procedure is appropriate for both
front right and left tracks.
1. With all four tracks installed on the ROV, place on
a flat surface with the ROV in 2WD and in neutral.
2. To check toe-in, push the front of the tracks
towards each other. Next, measure the length dif-
ference. The length has to be taken on the top of
the front wheels. The front dimension should be
same or greater by 1/4-in. than the rear dimension.
TT-031A
CAUTION
USE IN SNOW CONDITIONS ONLY. Failure to remove
in non-snow or warm conditions may cause the ROV
to overheat resulting in engine damage.
! WARNING
Misalignment of direction or improper tightening of
steering components may lead to loss of control of
the ROV. During the break-in period, the alignment
may change and must be verified.
! WARNING
ALWAYS verify all adjustments made, and that they
are identical between the right and left after test rid-
ing the ROV. These adjustments must be made on a
flat surface on grade. Improper or non-verified
adjustments can reduce performance and create pre-
mature wear of certain components. Make sure the
handlebar is not turning by itself during a turn or
when braking. If this is the case, the handlebar could
rotate suddenly when you do not expect it and you
could be ejected from the ROV posing a risk of seri-
ous injury.
! WARNING
If adjustments to the front anti-rotation require that
the rod end must be unscrewed, make sure that a
section of at least 25 mm (1 in.) of the threaded stud
remains inside; otherwise tearing of threads, loss of
control and injuries could result.