Parts Catalogue

11
TT-013
3. Insert the rod end of the anti-rotation arm into the
M12 carriage bolt of the A-arm bracket; then
secure using the M12 nut. Tighten to 61 ft-lb.
TT-065
NOTE: It may be necessary to move the track
frame around to align the hole and the carriage
bolt.
4. Repeat steps 1-4 for opposite side.
Rear Mounting Brackets (HDX and
XTZ)
NOTE: This procedure is appropriate for both left
and right rear track kits.
NOTE: The installation requires that the vehicle
be in 2WD and shifted into neutral.
1. Remove the components from the shipping pack-
age; then verify that there are no missing or dam-
aged components.
2. Place the ROV on a flat surface, and raise the rear
of the ROV using a support stand.
3. Remove the rear wheels; then remove and retain
the rear boot guards.
4. Remove the cap screw and nut securing the lower
A-arm to the rear knuckle assembly; then remove
the cap screw securing the rear suspension bracket.
TT-066
5. Position the rear suspension bracket (A) in place
and loosely secure it using a M10-1.5 x 140 mm
cap screw (B) and the M10 nylon nut (C).
TT-067A
6. Position the M8 cap screw (D) and secure it using
the two M8 flat washers (E), and M8 nut (F).
Tighten the M10 nylon nut to 34 ft-lb and the M8
nut to 17 ft-lb.
7. Repeat steps 1-6 for opposite side.
NOTE: The installation of the anti-rotation arm
must be done before the installation of the track
system on the ROV.
8. From the rear anti-rotation arm assembly, remove
the M16-2.0 nylon nut (A), spring washer (B),
spring (C), spring washer (D) sliding on the steel
slider sleeve, one rubber damper (E), and the
mounting bracket.