Parts Catalogue

Sprocket

Follow steps 1-5 of Tracks in this section; then do the

following:

1. Remove the M12 nut from the rod end of the anti-

rotation arm.

TT-022

2. Remove the wheel nuts of the ROV in order to free

the frame.

3. Set the track assembly on a flat clean surface; then

stand the frame on its wheels.

4. Remove the four M8 screws securing the sprocket

on the main axle with a 13-mm wrench and a 13-

mm socket.

5. Remove the used sprocket and discard it appropri-

ately (recyclable).

6. Install the new sprocket and secure it with the four

M8 screws. Tighten to 25 ft-lb.

7. Re-install the frame on the vehicle.

8. Tighten the M12 nut on the rod to 61 ft-lb.

9. Proceed to step 6 of Tracks in this section.

Plastic Guard

TT-023

1. Remove the torx screws securing the plastic guard;

then remove the guard.

2. Clean the inside of the steel bearing cage with a

dry cloth.

3. Grease the O-ring of the new plastic guard with

good quality grease.

TT-052

4. Install new plastic guard using six torx head

screws. Tighten securely.

Main Axle or Main Axle Bearings

The main axle is set up using a press. You must contact

an authorized Arctic Cat dealer for this operation.

TT-036

Wheel

Follow steps 1-4 of Tracks in this section; then do the

following:

1. Using a flathead screwdriver, remove the wheel

cap.

2. Loosen the M10 x 25 mm cap screw while holding

the wheel to the frame (for the tensioner wheel,

there is no screw, but a snap ring to be replaced).