Parts Catalogue

ManualsBrandsToro ManualsUtility VehicleToro 132-3140

 NOTE: Read these installation instructions thoroughly before beginning the installation process. Retain

these Installation Instructions for future reference.

Arctic Cat

Prowler

Installation Instructions - Accessory Kit

Form No. 0453-791

Roof Stereo Kit

(p/n 1436-635, 1436-837)

Kit includes:

p/n QTY DESCRIPTION

0430-114 1 Radio

0430-108 1 Jumper Harness

0486-285 1 Main Harness

0423-609 1 Machine Screw (Strap Mount)

8427-605 1 Nut

0453-791 1 Instructions

 NOTE: If installing Stereo Kit in a Headliner Kit

(p/n 1436-103) refer to the 1436-104 instructions.

1. Remove the LXC Roof from the vehicle (if

needed).

2. Using the Speaker manufacture's instructions,

cut out each template and place it in the center

of each speaker boss; then cut each hole using

an appropriate tool. See Fig. 1.

Fig. 1

UTV-348

3. Follow the Antenna manufacturer's instructions

for installing the antenna. Arctic Cat recom-

mends installing the antenna in location shown

below. See Fig. 2.

Fig. 2

UTV-347A

4. Remove the stereo din sleeve from Stereo, then

using a white marker, mark the LXC Roof (p/n

1436-500) using the stereo din sleeve as a tem-

plate.

 NOTE: Make sure the area marked is not larger

than the sleeve or the sleeve will not fit properly.

5. Using a suitable tool, cut along the marked area.

6. Using a suitable tool, remove enough area in the

bottom middle rear portion of the stereo din

sleeve. Insert Stereo Strap through the sleeve

and bend approximately 1/2-in. around the

sleeve. See Fig. 3 and 4.

Fig. 3

UTV-315A

Summary of content (3 pages)

PAGE 1
Form No. 0453-791 Arctic Cat® Prowler Installation Instructions - Accessory Kit Roof Stereo Kit (p/n 1436-635, 1436-837)  NOTE: Read these installation instructions thoroughly before beginning the installation process. Retain these Installation Instructions for future reference. Fig.
PAGE 2
Fig. 3 9. Secure the back of the stereo by installing Strap Mount Machine Screw through the hole in the roof (drill in step 5) and through the closest hole in the stereo strap and secure using a Nut. Tighten until snug.  NOTE: Before installing the speakers, be sure to drill a hole in the rear right-side corner so the accessory plug can be routed through. See Fig. 7. Fig. 7 UTV-351 7. Locate the center mounting location (A) where the windshield mounts to the roof; then using a 3/16-in.
PAGE 3
12. Connect Jumper Harness to the main harness. 13. Connect the Harness to the back of the stereo; and insert the stereo until it is fully seated. See Fig. 10. Fig. 10 14. Route the accessory plug through the hole and down through canopy tube and towards the accessory plug. Secure with cable ties.  NOTE: When connecting the stereo harness to a accessory plug on the vehicle please note that a orange and black connector (recommended) will cut power to the stereo harness when the key is turned off.